Skip to content
Alternative Finance

Commercial loans · Brokers and borrowers

Fixed vs variable loan calculator

This fixed vs variable loan calculator compares a fixed-rate loan with a variable-rate loan that starts lower and changes by an amount you set each year, up to a lifetime cap. It shows both payments, the highest variable payment on your path, the payment at the cap, the total paid under each and the average rise the variable rate must exceed before it costs more. Watch the cap payment: it is the scenario the lender has already priced and the one your cash flow must survive.

Cheaper under your rate path
Variable
Fixed monthly payment
$4,903.19
Variable starting payment
$4,713.32
Variable highest payment on your path
$4,954.70
Payment if the rate hits the cap
$5,622.00
Fixed total of payments
$411,868
Variable total on your path
$408,268
Variable must rise more than this to lose
1.25% on average

A variable rate wins if its average over the term stays below the fixed rate. Check the cap payment against your cash flow: it is the scenario the lender has already priced.

Formula

Fixed monthly payment = Loan amount × r ÷ (1 − (1 + r)^−m), where r = Fixed rate offered ÷ 12 and m = Term (months); Fixed total of payments = Payment × m

Variable path: in month 1 the rate is the Variable starting rate; at the start of each later year (months 13, 25, …) the rate becomes min(Lifetime cap, previous rate + Expected annual change); each month the payment is re-amortized on the remaining balance over the remaining months at the current rate; Variable total on your path = sum of those payments

Variable highest payment on your path = the largest monthly payment in that sequence; Payment if the rate hits the cap = the payment on the full loan over the full term at the Lifetime cap

Variable must rise more than this to lose = Fixed rate − Variable starting rate; the variable loan costs more only if its average rate over the term exceeds the fixed rate

Worked examples

Example 1: $300,000 over 84 months, 9.5 percent fixed versus 8.25 percent variable rising 0.5 a year, 14 percent cap

Use the defaults: Loan amount $300,000, Term 84 months, Fixed rate 9.5 percent, Variable starting rate 8.25 percent, Expected annual change +0.5 percent, Lifetime cap 14 percent. Fixed: r = 0.095 ÷ 12 = 0.0079167; Payment = $300,000 × 0.0079167 ÷ (1 − 1.0079167^−84) = $4,903.19; total = $4,903.19 × 84 = $411,868. Variable: year-one rate 8.25 percent gives a starting payment on $300,000 over 84 months of $4,713.32. At month 13 the rate becomes 8.75 percent and the payment is re-amortized on the balance then outstanding over the remaining 72 months; at month 25, 9.25 percent over 60 months; then 9.75, 10.25, 10.75 and finally 11.25 percent in year seven, all below the 14 percent cap. The payment rises each year, peaking at $4,954.70 in the final year. The total of all 84 variable payments is $408,268, which is $3,600 less than the fixed total, so the tool reports Variable as cheaper under this path. Payment at the cap = $300,000 at 14 percent over 84 months = $5,622.00. Break-even = 9.5 − 8.25 = 1.25 percent: the variable rate's average over the term must rise more than 1.25 points above its start before the variable loan loses. On this path it averages about 9.75 percent, but because the higher rates arrive when the balance is smaller, the loan still wins narrowly.

Example 2: the same loan with the rate falling 0.5 a year

Keep every default and change Expected annual change to −0.5 percent. The fixed side is unchanged: $4,903.19 a month, $411,868 in total. The variable rate now starts at 8.25 percent and falls to 7.75 at month 13, 7.25 at month 25, then 6.75, 6.25, 5.75 and 5.25 percent in year seven. Each re-amortization lowers the payment, so the highest payment on the path is the first one, $4,713.32, and the total of payments falls to $383,908, which is $27,960 below the fixed total. The cap payment is still $5,622.00 and the break-even is still 1.25 percent, because neither depends on the path. The lesson is the asymmetry: a rising path of the same slope costs the variable borrower $3,600 less than fixed, a falling path saves nearly $28,000 more, because a fixed loan cannot take advantage of falling rates without refinancing and paying whatever prepayment terms apply.

Example 3: $500,000 over 120 months, 8.75 percent fixed versus 7.5 percent rising a full point a year to a 13 percent cap

Enter Loan amount $500,000, Term 120 months, Fixed rate 8.75 percent, Variable starting rate 7.5 percent, Expected annual change +1 percent, Lifetime cap 13 percent. Fixed: r = 0.0072917; Payment = $500,000 × 0.0072917 ÷ (1 − 1.0072917^−120) = $6,266.34; total = $751,961. Variable: starting payment at 7.5 percent = $5,935.09. The rate rises to 8.5 percent at month 13, 9.5 at month 25, 10.5, 11.5, 12.5, and reaches the 13 percent cap at month 73, where it stays for years seven through ten. Re-amortizing on the shrinking balance, the payment climbs to a peak of $7,001.51. The total of payments is $802,022, which is $50,061 more than the fixed total, so the tool reports Fixed as cheaper. Payment at the cap on the full loan over the full term = $7,465.54. Break-even = 1.25 percent, the same gap as before, but a one-point annual rise blows through it by year three. The highest payment on the path, $7,001.51, is $735 a month above the fixed payment; that is the cash-flow stress the borrower would have carried for the last four years.

How variable business loans are priced and reset

A variable-rate business loan is priced as an index plus a margin. The index is a published rate the lender does not control: the prime rate for most bank and SBA loans, a Treasury yield or a term swap rate for larger commercial loans, and SOFR for syndicated and some securitized credit. The margin is fixed for the life of the loan. The Federal Reserve publishes the prime rate and Treasury yields in its H.15 statistical release; the prime rate itself moves in step with the federal funds target set by the Federal Open Market Committee, and the prime rate entry on Wikipedia describes the convention. SBA 7(a) loans are usually variable, pegged to prime or an approved alternative within maximum spreads the SBA sets by loan size.

Resets happen on a schedule the note specifies: monthly, quarterly or annually for most business loans, or at a fixed-period end for hybrid loans that are fixed for the first three, five or seven years and float afterwards. The fixed vs variable loan calculator models annual resets, because that is the simplest honest approximation and because the borrower's real question is about the direction and size of change over years, not months. Caps are less common on business loans than on consumer mortgages; where there is no contractual lifetime cap, enter the highest rate you believe plausible and treat the cap payment as a stress test rather than a contractual ceiling. Floors, which stop the rate falling below a level, are common and limit the benefit shown in example 2.

Reading the five numbers that matter

Outputs and what to do with each
OutputQuestion it answersWhat to do with it
Cheaper under your rate pathWhich loan costs less if rates follow my assumptionTreat as one scenario, not a forecast
Variable highest payment on your pathThe worst month under my assumptionCheck it against monthly cash flow with a margin
Payment if the rate hits the capThe worst month the contract allowsThe lender underwrote to this; so should you
Fixed and variable totalsLifetime dollars under eachThe difference is the premium you pay for certainty, or the saving for bearing risk
Variable must rise more than this to loseHow much the variable rate can rise on average before fixed was the better choiceCompare with how far the index has moved over past cycles

The break-even figure is the fixed rate minus the variable starting rate: 1.25 points in every example. It is an average-rate test, and the path matters because rate rises late in the term apply to a smaller balance than rises early on. That is why example 1's path, which averages about 9.75 percent against a 9.5 percent fixed rate, still comes out slightly cheaper on the variable side. A borrower who expects rates to rise by more than the break-even in the first half of the term should take the fixed rate; one who expects a flat or falling path, or a rise concentrated late, is usually better off variable.

The cap payment: the scenario the lender has already priced

A lender offering a variable rate underwrites the borrower's ability to pay at a stressed rate, not the starting rate. The cap payment in the tool is the full loan amortized over the full term at the lifetime cap, which is a conservative stress because the balance would be lower by the time the cap is reached. In example 1 it is $5,622 against a starting payment of $4,713, a 19 percent increase; in example 3 it is $7,466 against $5,935, a 26 percent increase. If the business's debt service coverage, computed with the DSCR calculator, falls below 1.0 at the cap payment, the variable loan is a bet that the cap is never reached, and the fixed loan is the prudent choice even at a higher starting cost.

The Federal Reserve's Small Business Credit Survey documents how rising rates affect small-firm finances in tightening cycles; the pattern is that firms with variable-rate debt and thin margins report the most stress. Brokers advising a borrower should present the cap payment alongside the starting payment on the first page, because a borrower who has only seen the starting payment has not been shown the loan.

Decision framework: certainty versus cost

  1. 1

    Start from the cap payment

    If the business cannot carry it with a margin, choose fixed and stop. Everything else is secondary.

  2. 2

    Set a path you can defend

    Use the index's history over past cycles for the size of annual moves, and the current shape of the yield curve for direction. A flat path is a reasonable base case; test a rising and a falling one.

  3. 3

    Compare the totals to the premium for certainty

    The fixed loan's extra cost on a flat path is the price of insurance. In example 1 the fixed loan costs about $190 more per month at the outset; decide whether that is worth never having to think about the rate.

  4. 4

    Check the prepayment terms

    A variable loan is usually prepayable at par; a fixed loan often carries a prepayment fee or yield maintenance. If there is a real chance of refinancing or selling the business, that flexibility is worth money. The prepayment savings calculator prices it.

  5. 5

    Consider a hybrid

    Fixed for three to seven years then floating, or a variable loan with a rate cap purchased separately, both sit between the extremes.

Term length changes the answer. On a short loan the variable rate has little time to rise and the starting discount dominates, so variable usually wins. On a long loan, like example 3, the rate has years to move and the balance stays large for longer, so the fixed rate's protection is worth more. The loan term comparison calculator shows how the payment and interest change by term; run this calculator at each term you are considering.

Where fixed and variable show up by product

  • SBA 7(a): usually variable, prime plus a spread capped by SBA rules, with quarterly or monthly resets; fixed-rate 7(a) loans exist but are less common. Size one with the SBA 7(a) loan calculator.
  • SBA 504: the SBA debenture portion is fixed for its full term; the bank's first lien is often fixed for a period and then resets.
  • Bank term loans: either, with hybrids common on commercial real estate; fixed rates are usually set off a Treasury or swap rate for the fixed period.
  • Bank lines of credit: almost always variable, prime plus a margin, resetting with prime.
  • Online term loans: usually fixed in dollar terms, quoted as simple interest or an APR; see the business loan rate comparison tool for putting those beside a prime-plus quote.
  • Equipment loans and leases: usually fixed for the term.

A borrower comparing a bank's prime-plus line with an online lender's fixed term loan is comparing rate risk with a higher certain rate; the honest comparison runs the line through this calculator at a rising path and compares the result with the online loan's effective APR. The Federal Reserve publishes its senior loan officer survey on bank lending standards, which signals whether fixed-rate bank credit is likely to be available at all for a given borrower profile.

Questions people ask

Is a fixed or variable rate better for a business loan?

Fixed if the business cannot carry the payment at the cap, if the term is long, or if rates are expected to rise by more than the gap between the two starting rates. Variable if the term is short, rates are flat or falling, the starting discount is large, or the loan is likely to be prepaid. The calculator shows both totals under your path and the payment at the cap.

What is the break-even rate rise between fixed and variable?

The fixed rate minus the variable starting rate: 1.25 points at the defaults. If the variable rate's average over the term rises by more than that, the variable loan costs more. Rises late in the term matter less than early ones because the balance is smaller, so a path that averages slightly above the break-even can still be cheaper, as example 1 shows.

How does the calculator model the variable payment?

The rate changes once a year by the expected annual change, never above the cap, and each month the payment is recalculated on the remaining balance over the remaining months at the current rate. That mirrors how most lenders re-amortize after a reset. The total of all monthly payments is the variable total on your path.

What index are variable business loan rates based on?

Most bank and SBA loans use the prime rate, which moves with the Federal Reserve's policy rate and is published in the Fed's H.15 release. Larger commercial loans use Treasury yields, swap rates or SOFR. The loan rate is the index plus a fixed margin; enter the sum as the variable starting rate.

Do variable business loans have rate caps?

Less often than consumer mortgages. Some notes include a lifetime cap or periodic caps; many include only a floor. Where there is no cap, use the field as a stress test by entering the highest rate you consider plausible, and make sure the business can carry that payment. The lender underwrote the loan at a stressed rate; the borrower should too.

Sources and further reading

Site calculators on the same topic

Related tools and guides

More commercial loans

Updated October 12, 2026 · By Alternative Finance editorial team

Next step

Turn the estimate into real offers

One request, several funding partners, side-by-side payback. Nothing is binding until you accept an offer.

  • Soft inquiry to request offers; a hard pull only if you proceed with a funder.
  • Decisions in as little as 24 hours for many products; funding often within days.
  • Use our calculators to check the true cost before you accept anything.

Check business term loan offers

Takes about a minute. Requesting offers does not affect your credit score. Free, no obligation.

We are not a lender or broker. Requests are forwarded to funding partners free of charge. How the site is paid.